Be sure that the device has cooled down before disassembling and cleaning. Do not handle the base, chamber or glass while hot.
CHAMBER CLEANING:
1. For a light cleaning, use a cotton swab dipped in 90%+ Isopropyl Alcohol to remove any residue as needed. Gently cleaning the gold contact points between the chamber and base will also help avoid potential connection issues.
2. For a deep cleaning, submerge the chamber in 90%+ Isopropyl Alcohol for 20-30 minutes. Again, do not handle or clean the chamber while still hot.
3. To remove the tether, gently pull back to dislodge the jacket from the housing rib of the chamber. Pull back from the other ribs until the jacket comes off completely.
4. To reattach the tether, align one of the open slots on the underside with the chambers housing rib and push down until fully seated.
5. The tether/carb cap can also be soaked for a deep cleaning. Be mindful that Isopropyl Alcohol often causes silicone to expand but not to worry, it will shrink back to a perfect fit.
6. After soaking, allow chamber to fully dry before use. Isopropyl Alcohol is highly flammable!
7. Hold jacket firmly during insertion / removal
8. When reinserting, align the 3 prongs on the chamber with the base. Do not force the chamber, this can cause irreversible damage!
BASE CLEANING:
1. Remove glass and chamber.
2. Gently clean the gold contact points and air path of the base using a cotton swab dipped in Isopropyl Alcohol.
3. Do not flood or soak the base with IPA.
4. Keep the USB port dry and free of IPA, water or dust.
5. Make sure that the base is completely seated inside the glass/attachment when reinstalling for optimal sealing.
GLASS CLEANING:
1. Carefully remove glass from base and submerge the glass in isopropyl alcohol.
2. Avoid using any other cleaning solutions or abrasive materials to clean the glass – soaking will be sufficient.
3. After soaking, rinse clean with water. Make sure it’s thoroughly rinsed prior to use.
4. Allow glass to fully dry before reattaching to base.
5. Be careful not to slide glass to avoid scratching – use our Proxy Travel pack for support
Comments
0 comments
Article is closed for comments.