1: Fully charge the device before first use. The lights will pulse white while charging and turn off automatically when complete.
2: Fill glass with water just above the air-holes. Do not fill glass while attached to base. X - Do not allow water into lower section!
3: Align inlet hole on the front of the glass with chamber. Carefully push the Front of glass into the base, then the back.
4: To lock / unlock the device, hold down the button for 3 seconds. (Preserves battery between uses)
5: Single click to toggle through heat settings. BLUE (Low) - GREEN (Medium) RED (High) - WHITE (Super High)
6: Use loading tool or a Puffco Dual Tool to place contents on the bottom surface of the bowl (not the sides).
7: Place carb cap on top of chamber. Press down until snug.
8: Double click to initiate heat-up. Press and hold button anytime to exit. Pulsing light indicates heat-up mode is active.
9: Device will vibrate and lights will flash 3 times when ready. Inhaling gently will produce the best results.
10: Use a Dual Tool to clean the chamber after each use. Wipe Gently in a circular motion.
Comments
0 comments
Article is closed for comments.