1. Make sure that your Peak is fully charged before your first use. The white light on the unit will pulse while it's charging and will automatically turn off once fully charged. The Peak should take about 2.5 hours to fully charge. Use only the micro USB charger included with your Peak to do so, using different charging bricks can potentially damage the device and will void your warranty.
2. Fill the glass attachment with water, just above the air-holes. Do not allow any water in the lower section of the glass (see included instructions for details) and do not fill the glass attachment water while attached to the base.
3. You can then attach the glass to the base of the Peak, aligning the inlet hole on the front of the glass with the atomizer. Then carefully pushing the front of the glass into the base, then the back.
4. To lock/unlock the device, hold down the button for 3-5 seconds.
5. Single click to toggle through heat settings; BLUE-GREEN-RED-WHITE
6. Use loading tool to place contents on the bottom surface of the bowl.
7. Place carb cap on top of atomizer.
8. Double click to initiate heat-up; the device will take about 20 seconds to heat up fully. Press & hold button at any point to exit heating cycle.
9. Device will vibrate and lights will flash 3 times when ready for use.
10. Use a cotton swab to clean the bowl after each use.
Comments
0 comments
Article is closed for comments.